|
|
| Romy the Cat's
personal site dedicated to advanced audio and evolved music reproduction
techniques
|
|
 |
|
|
|
|
|
[quote user="Romy the Cat"] 1) Horn loaded drivers are narrow-bandwidth transducing system. The wider range a horn channel covers the more it conflicts with restrictions of own topology.
2) All channels shell have strictly parallel axis
3) ...
|
|
1) Horn loaded drivers are narrow-bandwidth transducing system. The wider range a horn channel covers the more it conflicts with restrictions of own topology.
2) All channels shell have strictly parallel axis
3) All channels shell be time-a...
|
|
[quote user="Romy the Cat"]I changed the new flash at my site to “Ok, the midbass horn project is successfully over. Over 3 months, over 400 posts, over 180 pictures… all publicly available…” The project started physically on July 16, 2010, ended...
|
|
[quote user="oxric"] My mistake. I should not use the term Lecleach on this site. [/quote]
There is absolutely nothing prohibitive in Lecleach profile, it works very nice for HF but the La profile shall not be used in cases where vertical clea...
|
|
[quote user="twogoodears"]Dear Roman and all... also unrequested/unsolicited, MUST give my opinion on the above... I had to translate my 2,3 meters from my Gotorama speakers system, and obtained 7,6 or so feet... it's angled 110° in front of my h...
|
|
[quote user="Romy the Cat"]
Well, acg, I am not wild about your idea of the curved frame,
primary on the reason of esthetics but it is your speaker not mine and you
shall do whatever pleases you. A few mandatory things that I would like to
men...
|
|
I believe that the Arum Cantus is typical of most ribbons in mirroring one of the principal failings of MC cartridges, a rising top end (over 20k), although I have not actually heard this - at all - with my own small Arum Cantus, and I just go n...
|
|
[quote user="RF at Ona"] Romy,I might have overlooked something on your site but I understand that your ULF amp is driven directly by the preamp line stage. If that is the case, you may want to consider an old technique for integrating subwoofers...
|
|
[quote user="haralanov"] Romy, the actual sound benefit of this 4-channel upper bass configuration, is rather in the type of sound presentation. The commonly used single upper bass horn (or direct radiator) sitting under the midrange horn, gives the ...
|
|
[quote user="jessie.dazzle"] Resonant frequency :
I did not try to measure it. Can anyone confirm the following : I assume this parameter is most easily determined by playing a series of tones at constant signal strength (volume setting) whi...
|
|
Yes, it turned out to be the emails from GOTO importer. I am not completely understood if the horn at the picture above is an official GOTO product. The Ming Su said that the horn was build locally by Jeffrey Jackson with the support of GOTO but then...
|
|
[quote user="chaos"]macondo: searched it, but its far out;-) you and jezzie work on another base.[/quote]
Klaus, it does not need to be searched - Macondo has own page:
http://www.goodsoundclub.com/MacondoAcousticSystem.aspx
I would like to note t...
|
|
Coops, I less care about the attacks on me, I know that I am a pH-indicator of Moronity among audio freaks. So, if some specific idiots out there are not happy about me then… it is good for me. The higher we climb in mountains the stronger wind and l...
|
|
Yes, the crossover looks fancy :) More than that it does the job. The vacuum caps are only for the tweeter and the upper-mid beryllium. Still they are bridged with micas as they wont do much alone. Adding vacuum caps smoothens the transitions and sou...
|
|
[quote user="drdna"] Now I have had the EdgarHorns in my system for a number of weeks and have been moving them around the room and moving things in the room around to make them sound their best. [/quote]
If you are not familiar with horns then it u...
|
|
Romy,
I value your input so don’t pull out so quickly.. I was expecting your reaction though.
I,m not the 'typical Audio Moron' type, just planning ahead of time because remodeling is involved. Imagine YOU were forced to move into this room with yo...
|
|
I meant to have this post as a separate thread in the “Playback Listing section “– the “load” of it is well-deserve it but then I decided that it would be too easy for the readers of my site. The subject of this post is well related to results of...
|
|
Just to answer a couple of question and post some more...
The Mouth changing sectors in the horn, according to the preliminary data posted here, would be as follow:
For the 40 hz horn: 4¨ Throat to 6¨ = 53 cm
...
|
|
[quote user="Romy the Cat"] In fact I do feel that
my MF and upperbass are very good integrated. But again, I might not know how
different it might be if it was otherwise. [/quote]
Exactly!
Some time ago I also thought my upper bass channel is ...
|
|
[quote user="Dresden"]… One very important component I'm leaving out of the cost of the horn is amplification (the horns will be active, using class-D amps). The reason for my choosing class-D amplification is that the modules and various compo...
|
|
The AudioFederation guy posted pictures from RMAF show with Cogent room. (The images are courtesy to http://www.audiofederation.com)
I was wrong in my previous post, as Cogent did demonstrate their loudspeakers with Ionovac ion tweeter. Yester...
|
|
I sometimes visit an Australian site and familiarize myself
with progress of “acg” who it trying to build Macondo like acoustic system.
http://www.stereo.net.au/forums/index.php/topic/75784-deep-end-diy-my-first-speaker-project
A few weeks a...
|
|
Here is the list of the thing to do with Vitavox S2 in order to use it in 4-ways installations. The S2 must not be used in 2, 3 ways systems. It possible to do with S2 whatever you wish but pretty much any other way to utilize them produces some very...
|
|
(I screwed my first attempt to respond by trying to get fancy with the code, so here it is again)Romy the Cat wrote : "...there is another solution that you might consider, that might be viewed as compromise for one-side as might not be view is compr...
|
|
Considering the conclusions of my recent experiences that I described in the following thread:
http://www.GoodSoundClub.com/TreeItem.aspx?PostID=6876
I would like to share some of my observation that the people who would go multi-way horns might fi...
|
|
Jessie, there is another solution that you might consider, that might be viewed as compromise for one-side as might not be view is compromised from other side. If to allowed ourselves to close eyes to midbass timing-integration and if the geography o...
|
|
Yesterday I retune and recalibrated the whole Macondo and Milqs, tubes, drives, horns, angles, timing… everything. The snapshot or fully calibrated Macondo that I made in the page 14 of this thread was phenomenal help. I think everyone who runs m...
|
|
[quote
user="noviygera"]You provided very good starting points on the driver
selection and I am also corresponding with a gentleman that may help me with
actual horn design. I have found a couple of drivers that seem to work based on
your guideli...
|
|
hmm...I didn't realise I had left my browser logged-in to your site (I left my PC on over night, downloading some files).'..the only advantage that class-D amplification has is cost, size, heat generation and power.'In my eyes, that's more than I cou...
|
|
Romy wrote :"...The table on the picture above is very good but it is $180 each. It will be my way out if I do not found anything beter..."Romy,
$180 does not seem expensive for such a table; for that price it is likely to have been "Made in China",...
|
|
|
|
|
All context of this site except the Forum's posts
Copyright © Roman Bessnow 2004-2024
All messages within the Site’s Forum Copyright © by
authors of the posts
|
|
Last 24-hours posts: |
0 |
|
 |
|
|
Total human visitors: |
42,921,507 |
|
|
|
|
|
|